Central Heating furnace designs are
certified by the American Gas Association
for both natural and L.P. gas. Limit
setting and rating data were established
and approved under standard
rating conditions using American National
Standards Institute standards.
Durable, cycle tested, heavy gauge
aluminized steel heat exchanger
quickly transfers heat to provide warm
conditioned air to the structure. Low
energy power vent blower, to increase
efficiency and provide a
positive discharge of gas fumes to the
Multiport Inshot burners will give years
of quiet and efficient service. All models
can be converted to L.P. gas
without changing burners.
The variable speed blower motor has
sufficient airflow for most heating and
cooling requirements and will switch
from heating to cooling speeds on demand
from room thermostat. The
blower door safety switch will prevent
or terminate furnace operation when
the blower door is removed.
The Freedom 95 has a special type
29-4C stainless steel secondary
heat exchanger to reclaim heat from
flue gases which would normally be
Heavy gauge steel and "wraparound"
cabinet construction is
used in the cabinet with baked-on
enamel finish for strength and beauty.
The heat exchanger section of the cabinet
is completely lined with foil faced
fiberglass insulation. This results in
quiet and efficient operation due to the
excellent acoustical and insulating
qualities of fiberglass. Built-in bottom
pan and alternate bottom, left or right
side return air connection provision.
The Freedom 95 High Efficiency Gas
Furnaces utilize an Adaptive Heat Up
Silicon Nitride Hot Surface Ignition system,
which eliminates the waste of a
constant burning pilot. The integrated
system control lights the main burners
upon a demand for heat from the room
thermostat. Complete front service access.
a. Low energy power venter
b. Vent proving pressure switch.